FAQs

We don’t keeping doors on Stock as we work only with individual sizes and requirements of our clients.

Yes, we offer installation of doors at additional cost for the doors bought from us.

The period of construction is 30 days.

The doors are installed on the finished floor and finished walls.

Routing is a high performance method of cutting, widely used for treatment of flat and shaped surfaces for cutting of straight and helical channels with various profiles.

All ledges that we produce are stirred or “floating”, i.e. sills are L-shaped and have a pen, which enters the hole in the frame of the interior doors in order to compensate for the curvature of the masonry wall.

We applied a drawing with an explanation, to help you determine what type of door you need, according to the manner and direction of their opening:

These hinges for doors are installed in interior spaces with stylish and sleek design.

1. Paper filling “honeycomb”
Filling the interior doors made by us in BDS – Bulgarian state standard is made of special paper “honeycomb”.

2. Dense filling of “sandwich” type with massive boards and MDF
If necessary, the interior doors can be with dense solid filling of “sandwich” type along the whole leaf with massive boards glued with 6 mm MDF in the middle for better density and weight of the interior door leaf.

3. . Flux filling of “perforated chipboard” type
This type of filling is solid or perforated chipboard (tightly glued wood particles) and is often used for additional sound insulation in the execution of interior doors, as well as for higher density and thermal insulation in the production of the filling of entrance doors.

Veneer is a thin sheet of wood, usually sticky on the surface of various boards MDF.
Veneer is produced by cutting or called. development of pre-processed section of logs.
Veneer can be tangential or radial, depending on the direction of cutting. In radial cutting wood veneers are cut at right angles to the annual rings, creating the right fibers effect. In tangential cutting veneers cutting be made parallel to the center.

A product manufactured on the basis of wood obtained by grinding residue of hard or soft wood to wood fibers, often in combination with wax and rubber as a binder.
From the resulting mass is formed plates at high temperature and pressure.

The final product consists of individual fibers (not veneer) and can be used as a building material similar to plywood. The resulting MDF is stronger and much more dense than plywood or chipboard normal – chipboard.

Its name is derived from the difference in the densities of the fiber plates. Widespread production of MDF began in the early 80s of the last century.

Mainly, interior doors are produced with rebated leaves, and at the customer’s request, the leaf can also be made without rebates.

The non-rebated doors are also called “wallpaper doors” due to the fact that the leaf in the closed position is on one plain with the wall and the joint between the leaf and the door frame remains uncovered (visible).